Citizen-systems CMP-10 User Manual download pdf (Page 27)

— 23 —

4.4

Communication Via Serial Port (Cable)

For communication with RS-232C, prepare dedicated serial cable.

Open the serial port cover and while holding the connector with the

wording marked “Push” faciing upward, insert the connector into the

serial port.

Here, hold the connector with the surface marked “Push” down.

Connect the other end of the cable of the cable to the device to be

connected.

To disconnect the connector, securely do it while pressing the portion

marked “Push”.

To replace the serial port cover, press in the rubber packing till the cover

seats firmly.

CAUTION!

If the cable is connected with Power ON, turn the Power OFF once and then turn

the Power ON again to activate the connection with serial cable.

Set the flow control setting of the device to be connected to Xon/Xoff. In case

of hardware control (DTR/DSR control), the Power switch may become disabled.

Lift and open the serial port cover.

Rubber projection

This part is fixed to the body;

therefore, it cannot be detached

as shown in the figure.

Insert serial cable:

Serial port cover

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

No comments

Citizen-systems CMP-10 User Manual Page 27