Citizen-systems CMP-10 User Manual download pdf (Page 31)

— 27 —

5. FUNCTION

5.1 Auto Power OFF

Power is automatically cut off after a specified period of time, during

which no command is sent to the printer and the LF switch has not been

pressed.

The default setting of this time duration is 10 minutes, however, the period

can be custom set by the user with a special command to the printer.

(see Command Reference List)

The behavior of the printer at the operation of Auto Power OFF is the

same as that when power is turned OFF by the Power switch.

5.2 Interface Selection

The interface is automatically selected depending on the presence or

absence of connection to the serial port with a serial cable connector.

● At POWER ON, no cable is connected, the IrDA interface is selected.

● At POWER ON, the cable is connected, the Serial interface is selected.

CAUTION!

If cable is connected with printer power ON, selecting IrDA interface remains

valid. If you want to use the serial interface, turn the printer power OFF once,

connect the serial cable, and then turn the printer power ON again.

5.3 Low Battery Detection

Battery charge level is monitored at Power ON, before paper feeding,

and before printing.

When the buzzer sounds three times or “Low Battery” is printed,

immediately charge the battery.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 39 40

No comments

Citizen-systems CMP-10 User Manual Page 31